TM 5-3895-383-24
Type 1
Type 2
3.
Lubricate the inlet & exhaust valves with clean engine
oil and install the inlet & exhaust valves in the cylinder
head. Install the valve seals down against the valve
guides as shown.
4.
Position valve spring (1) and the spring retainers (3).
Use Tooling (A) to compress valve spring (1). Install
retainer locks (2). A small amount of grease can be
used to hold the retainer locks in position during
assembly.
5.
Repeat this process for all of the inlet & exhaust valves.
End By:
a.
install cylinder head assembly
Valve Guides
Remove & Install Valve
Guides 1104-010
Tools Needed
A
1U-6685
Guide And Insert Tool Group
1
Start By:
a.
remove cylinder head assembly
b.
remove inlet & exhaust valves
1.
Use Tooling (A) and drive valve guide (1) from the
cylinder head.
NOTE:
The following steps are for the installation of the
valve guides.
2.
Position the valve guide. Carefully tap valve guide (1) to
start the guide into the cylinder head. Position Tooling
(A) to finish driving the valve guide into the cylinder
head to the dimension shown above.
End By:
a.
install inlet & exhaust valves
b.
install cylinder head assembly
8-40
