TM 5-3895-383-24
5.
The oil hole for the front bearing is aligned with the oil
hole in the block. Locate the joint in the front camshaft
bearing in the position as illustrated. For more
information
refer
to
the
Specifications
section,
SENR3582.
End By:
a.
install camshaft
Engine Oil Pan
Remove & Install Engine
Oil Pan 1302-010
Fluid Spillage Containment
Care must be taken to ensure that fluids are contained during
performance of inspection, maintenance, testing, adjusting and
repair of the machine. Be prepared to collect the fluid with
suitable containers before opening any compartment or
disassembling any component containing fluids. Refer to
"Tools And Shop Products Guide", NENG2500 for tools and
supplies suitable to collect and contain fluids in Caterpillar
machines. Dispose of fluids according to local regulations and
mandates.
1.
Drain the oil from the engine into a suitable container for
disposal.
2.
Remove bolts (1) and the washers that hold engine oil
pan (2) to the cylinder block. Remove the engine oil
pan and gasket. Do not pry or gouge engine oil pan
sealing surface. Tap the engine oil pan with a rubber
mallet to loosen the engine oil pan if it remains in place.
NOTE: The following steps are for the installation of the
engine oil pan.
3.
Clean the mating surfaces of the engine oil pan and the
cylinder block. Apply 1U-8846 Sealant to the four
places at the tee joints of the front housing to the
cylinder block and at the flywheel housing, or seal
carrier, to the cylinder block. Use approximately 0.5 mm
(.02 inch) at each of four places. Do not apply liquid
gasket on the engine oil pan gasket or on the gasket
surface of the engine oil pan.
8-45
