TM 5-3895-382-24
NOTE:
After the radiator has been installed, fill the
cooling system with coolant to the correct level.
See the Operation & Maintenance Manual for the
correct procedure.
NOTE:
For installation of the radiator, reverse the
removal steps.
End By:
a.
install engine enclosure
Hydraulic Oil Cooler
Remove & Install Hydraulic Oil
Cooler 1374-010
Tools Needed
A
6V-2156
Line Brackets
2
Start By:
a.
remove radiator
At operating temperature, the hydraulic oil tank is hot and
under pressure. Hot oil can cause burns. Remove the fill
cap on the hydraulic oil tank only when the engine is
stopped and the fill cap is cool enough to touch with your
bare hand.
1.
Drain the hydraulic oil from the hydraulic oil tank.
The capacity of the hydraulic oil tank is 72 liters
(19 U.S. gal).
2.
Disconnect hose assemblies (1) and (2) from hydraulic
oil cooler (3). Cap and plug immediately.
3.
Remove the two bolts that fasten plate (6) to shroud (5)
and the hydraulic oil cooler. Move the bracket and two
hoses out of the way.
4.
Remove the four bolts and one half of fan guard (4). It
is necessary to remove one half of the fan guard to gain
access to bolts (7).
5.
Remove two bolts (7), the washers and rubber mounts
that fasten hydraulic oil cooler (3) to the mount
assembly.
9-11
