TM 5-3895-382-24
6.
Attach Tooling (A) and a hoist to hydraulic oil cooler (3)
as shown. Remove six remaining bolts (8), and remove
the hydraulic oil cooler from the shroud. The weight of
the hydraulic oil cooler is 34 kg (75 lbs).
NOTE:
After the hydraulic oil cooler has been installed,
fill the hydraulic oil tank to the correct level. See
the Operation & Maintenance Manual for the
correct procedure.
NOTE:
For installation of the hydraulic oil cooler, reverse
the removal steps.
End By:
a.
install radiator
Engine (CS-433C & CP-433C)
Remove & Install Engine
1000-010
Star By:
a.
remove engine enclosure
b.
* tilt operators platform
* This procedure is in the CS-431C, CP-433C & CS-433C
Machine Systems Disassembly & Assembly module, Form No.
KENR2643.
At operating temperature, the hydraulic oil tank is hot and
under pressure. Hot oil can cause burns. Remove the fill
cap on the hydraulic oil tank only when the engine is
stopped, and the fill cap is cool enough to touch with your
bare hand.
1.
Drain the hydraulic oil from the hydraulic oil tank.
The capacity of the hydraulic oil tank is 72 liters
(19 U.S. gal).
2.
Remove the two nuts and bolts that fasten muffler (1) to
the engine.
3.
Loosen bolt (3), and remove the clamp and muffler (2)
from the engine.
4.
Loosen the two hose clamps, and remove hose (2) from
the turbocharger and air cleaner housing.
5.
Mark or Identify all electrical wires for installation
purposes. Slide the rubber down two electrical wires
(6). Remove the nut, and disconnect the two electrical
wires from the starter.
6.
Remove the plastic plug, and disconnect electrical wire
(4) from the starter.
7.
Remove the bolt that fastens ground strap (5) to the
flywheel housing.
8.
Disconnect hose assembly (7) from the primary fuel
filter. Cap and plug immediately. Remove the bolt and
clip that fastens hose assembly (7) to the flywheel
housing.
9-12
