TM 5-3895-382-24
5.
Remove two bolts (2), and remove fuel filter (3) from the
bracket.
NOTE:
For installation of the fuel filter, reverse the
removal steps.
Disassemble & Assemble Fuel Filter
1261-017
Start By:
a.
remove fuel filter
1.
Remove ring (8) and element (7) from filter base (5).
2.
Remove seal (6) from the filter base. Check the seal for
wear or damage, and replace if necessary.
3.
Remove nut (1), cap (2) and plug (4) from the filter
base. Remove seal (3) from the cap. Check the seal
for wear or damage, and replace if necessary.
NOTE:
For assembly of the fuel filter, reverse the
disassembly steps.
End By:
a.
install fuel filter
Fuel Lift Pump
Remove & Install Fuel Lift Pump
1258-010
1.
Disconnect fuel lines (1) and (3) from fuel lift pump (2).
Cap and plug immediately.
2.
Remove four bolts (4). Remove fuel lift pump (2) and
the gasket from the engine. When installing the fuel lift
pump, tighten four bolts (4) to a torque of 22 N·m
(16 lb-ft).
NOTE:
If the fuel lift pump is difficult to remove, rotate
the crankshaft until the camshaft eccentric, which
operates the fuel lift pump, is in a position which
will free the lever on the fuel lift pump.
NOTE:
When installing the fuel lift pump, make sure the
camshaft eccentric is in the minimum lift position
before the fuel lift pump is installed. Clean the
face of the fuel lift pump and the cylinder block
before installing the fuel lift pump.
NOTE:
For installation of the fuel lift pump, reverse the
removal steps.
9-8
