TM 5-3895-382-24
NOTE: After the fuel lift pump has been installed it may
be necessary to prime the fuel system. Refer to
the Operation & Maintenance Manual for the
correct procedure.
Oil Filter, Oil Filter Base & Oil
Cooler
Remove & Install Oil Filter,
Oil Filter Base & Oil Cooler
1306,1318 & 1378-010
1.
Loosen the two clamps that fasten oil lines (4) to oil
cooler (7).
2.
Disconnect electrical connector (1) for the engine oil
pressure switch.
3.
Remove three bolts (2) and nut (3), and remove oil filter
(5), oil filter base (6) and oil cooler (7) as a unit from the
engine and oil lines (4). Cap and plug immediately.
NOTE: For Installation of the oil filter, oil filter base and
oil cooler, reverse the removal steps.
Engine Enclosure
Remove & Install Engine Enclosure
7263-010
1.
Loosen the hose clamp, and remove hood (1) from the
air cleaner housing.
2.
Loosen the bolt, and remove exhaust pipe (2) and the
clamp from the muffler.
3.
Remove the eight bolts, and remove top panel (3) from
the machine.
4.
Remove two bolts (4) that fasten backup alarm (5) to the
cowling. Mark the two electrical wires for assembly
purposes, and disconnect them from the backup alarm.
5.
For assembly purposes, mark the two electrical wires on
two rear lights (6). Disconnect the two electrical wires
from each of the rear lights.
6.
Remove the cable ties that fasten electrical harness (7)
to the cowling, and move the electrical harness out of
the way.
9-9
