TM 5-3895-379-23-1
0195
GROUP I TERMINAL ASSEMBLY - Continued
NOTE
Wire should be positioned so larger wings of terminal will crimp around insulation and smaller
wings will crimp around exposed bare wire.
4.
Position wire (Figure 11, Item 2) on terminal (Figure 11, Item 1).
5.
Press handle(s) of crimp tool together until ratchet releases and crimp is complete.
NOTE
Locking tab should be positioned toward notch in connector cavity when properly installed.
6.
Pull wire (Figure 11, Item 2) and terminal (Figure 11, Item 1) back through connector (Figure 11, Item 4) until
seated.
7.
Seat seal (Figure 11, Item 3) into connector (Figure 11, Item 4).
1
2
1
2
4
3
M1004SWR
Figure 11.
Wiring Repair.
END OF TASK
GROUP II TERMINAL DISASSEMBLY
NOTE
Connector is removed by gently prying up on clip and pulling on connector or pushing in
on clip on connector.
All Group II connectors are repaired the same way. Number of wires in connector may
vary. The general shape of Group II connectors may vary.
Both halves of connectors are repaired the same way.
1.
Disconnect connector (Figure 12, Item 1).
2.
Unlatch and open two secondary locks (Figure 12, Item 2) on connector (Figure 12, Item 1).
03/15/2011Rel(1.8)root(maintwp)wpno(M00133)