TM 5-3895-379-23-1
0195
GROUP II TERMINAL DISASSEMBLY - Continued
6.
Insert 1 in. (2.5 cm) of wire (Figure 14, Item 2) through new wire seal (Figure 14, Item 1).
CAUTION
Strip wire after placing it through seal to prevent damage to individual wire strands.
7.
Strip end of wire (Figure 14, Item 2) leaving 1/4 in. (0.64 cm) of bare wire.
2
1
M1007SWR
Figure 14.
Wiring Repair.
END OF TASK
GROUP II TERMINAL ASSEMBLY
1.
Insert new terminal (Figure 15, Item 3) in locating hole of crimp tool (Figure 15, Item 5) using proper hole
according to gauge of wire (Figure 15, Item 2).
2.
Slide seal (Figure 15, Item 5) down to end of insulation (Figure 15, Item 1).
1
2
3
5
4
M1008SWR
Figure 15.
Wiring Repair.
03/15/2011Rel(1.8)root(maintwp)wpno(M00133)