TM 5-3895-379-23-1
0195
MALE CABLE CONNECTOR REPLACEMENT
1.
Slide outer shell (Figure 5, Item 1) back from wire (Figure 5, Item 5).
2.
Remove C-washer (Figure 5, Item 2) from wire (Figure 5, Item 5).
3.
Remove contact (Figure 5, Item 3) from wire (Figure 5, Item 5).
4.
Trim end of wire (Figure 5, Item 5) as needed to make an undamaged end.
NOTE
If trimming causes wire to become too short, refer to WIRE SPLICING USING BUTT
CONNECTORS or WIRE SPLICING USING SOLDER METHOD in this work package.
5.
Remove 3/8 in. (1.0 cm) of insulation (Figure 5, Item 4) from end of wire (Figure 5, Item 5).
6.
Install contact (Figure 5, Item 3) over bare end of wire (Figure 5, Item 5).
7.
Crimp contact (Figure 5, Item 3) securely in place.
8.
Install C-washer (Figure 5, Item 2) to wire (Figure 5, Item 5).
9.
Slide outer shell (Figure 5, Item 1) over C-washer (Figure 5, Item 2) and contact (Figure 5, Item 3).
10.
Be sure no bare wire (Figure 5, Item 5) is visible outside of outer shell (Figure 5, Item 1).
1
2
5
3
4
M0998SWR
Figure 5.
Male Cable Connector Replacement.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00133)