TM 5-3895-382-24
Starter
Remove & Install Starter
1518-010
1.
Open the engine access door on the left side of the
machine.
2.
Turn the disconnect switch to the OFF position.
3.
Mark or identify all electrical wires for installation
purposes. Slide the rubber cover down two electrical
wires (5). Remove the nut, and disconnect the two
electrical wires from starter (1).
4.
Remove plastic plug (2), and disconnect electrical wire
(4) from the starter.
5.
Remove three bolts (3), and remove starter (1) from the
engine.
NOTE:
For installation of the starter, reverse the removal
steps.
Alternator
Remove & Install Alternator
1405-010
1.
Open the engine access door on the left side of the
machine.
2.
Turn the disconnect switch to the OFF position.
3.
Mark or identify all electrical wires for installation
purposes. Disconnect electrical wires (3) and (5) from
alternator (2).
4.
Loosen bolt (1). Remove bolt (6). Rotate pulley guard
(4) out of the way. Rotate the alternator toward the
engine, and remove two V-belts (7) from the alternator
pulley.
5.
Remove bolt (1), and remove alternator (2) and pulley
guard (4) from the engine.
NOTE:
If the alternator pulley was removed, tighten the
alternator pulley nut to a torque of 65 to 74 N· m
(48 to 55 lb-ft).
NOTE:
When installing the alternator, the alternator
pulley must be aligned with the crankshaft pulley
within 2.4 mm (0.09 In).
NOTE:
For installation of the alternator, reverse the
removal steps.
9-5
