TM 5-3895-379-23-1
0196
INSPECTION AND TESTING
Wiring and electrical inspection and repair is presented in General Wiring Repair (WP 0195). Electrical testing is
presented in Electrical General Maintenance Instructions (Volume 2, WP 0280).
END OF TASK
REMOVAL
NOTE
Tag and mark all wires prior to removal.
Cut electrical tiedown straps as needed for removal.
1.
Disconnect engine wiring harness connector (Figure 1, Item 3) from connector (Figure 1, Item 7).
2.
If damaged, remove nut (Figure 1, Item 1), bracket (Figure 1, Item 4), washer (Figure 1, Item 5), and screw
(Figure 1, Item 6) from frame assembly (Figure 1, Item 8).
3.
Loosen screw (Figure 1, Item 9) in connector (Figure 1, Item 10) and disconnect connector from engine wiring
harness connector (Figure 1, Item 2).
4.
Remove three screws (Figure 1, Item 11), lockwashers (Figure 1, Item 12), and engine wiring harness
connector (Figure 1, Item 2) from frame assembly (Figure 1, Item 8). Discard lockwashers.
0196-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00134)
