TM 5-3895-383-24
Drum Support Housing
(CS-563D & CP-563D)
Remove & Install Drum Support Housing
(CS-563D & CP-563D) 5656-010
Tools Needed
A
6V-2082
Hook Assembly
1
138-7574
Link Bracket
1
Start By:
a.
remove drum
1.
Drain the oil from the drum support housing into a
suitable container. The capacity of the drum support
housing is 2 liters (0.5 U.S. gal).
2.
On the vibratory side of the drum assembly, remove two
bolts (1), washers and vibratory motor (4) from the drum
support housing. Remove O-ring seal from vibratory
motor. Check O-ring seal for wear or damage and
replace if necessary. When installing vibratory motor,
apply 95-3263 Thread Lock on the threads of two bolts
(1).
3.
Attach lifting strap and hoist to bracket (2).
4.
Remove eight bolts (3), and remove two brackets (2),
and plate (5) from the drum support housing. The
weight of the two brackets and plate as an assembly is
117 kg (257 lb). When installing, apply 9S-3263 Thread
Lock on the threads of eight bolts (3).
5.
Attach a lifting strap and hoist to bracket (2) as shown.
Remove four bolts (6), and two brackets (2). The weight
of each bracket is 41 kg (90 lb).
6.
Remove the bolt from each of four mounts (7), and
remove the mounts from plate (5).
7.
Attach Tooling (A) to drum support housing (8).
8.
Remove eight bolts (9), and drum support housing (8).
The weight of the drum support housing is 41 kg (90 lb).
NOTE:
For installation of the drum support housing,
reverse the removal steps.
NOTE:
Apply 6V-4876 Molykote lubricant to shaft splines
before installing the vibratory motor.
NOTE:
After the drum support housing has been
installed, fill the housing with oil to the correct
level. See the Operation & Maintenance Manual
for the correct procedure.
End By:
a.
install drum
14-87
