Disassemble & Assemble Drum
Support Housing 5656-010
remove drum support housing
Make sure the outside of the drum support housing is
dean and free of dirt and debris.
Put alignment marks on the housing and cover to aid in
Install the drum support housing on a suitable stand or
move to a clean fiat area for disassembly. The weight
of the drum support housing is 41 kg (90 lb).
For the drum support housing removed from the right
side (vibratory side) of the drum assembly, remove
spacer (1) and O-ring seal (5). Check the O-ring seal
for wear or damage and replace if necessary.
For the drum support housing removed from the left side
of the drum assembly, remove the four bolts, cover and
O-ring seal. Check O-ring seal for wear or damage and
replace if necessary.
Remove three plugs (6) and magnetic plug (7).
Bend lock nut (2) away from spindle (12).
Use tool (A) to remove lock nut (2).
During assembly, 4C-9507 Retaining Compound
was used on lock nut (2). To remove the lock nut,
it may be necessary to slightly heat lock nut (2).
Remove washer (3).