TM 5-3895-382-24
Illustration 181
1.
Use Tool (A) in order to install the camshaft bearings in
the cylinder block.
2.
Install camshaft bearings (1) in the cylinder block.
End By:
a.
Install the camshaft. Refer to Disassembly and
Assembly, "Camshaft - Remove and Install".
Engine Oil Pan - Remove and Install
SMCS Code: 1302-010
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
Illustration 182
Typical example.
1.
Remove oil pan drain plug (2) and the O-ring seal.
Drain the engine oil into a suitable container for storage
or disposal.
2.
Remove twenty bolts (1).
3.
Remove engine oil pan (3) and gasket (4).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Clean all surfaces thoroughly. Inspect the condition of
the gasket. Replace the gasket, if necessary.
Illustration 183
Typical example.
2.
Install gasket (4) and engine oil pan (3).
3.
Install twenty bolts (1). Tighten the bolts to a torque of
22 Nm (16 lb-ft).
4.
Install the O-ring seal and oil pan drain plug (2). Tighten
the drain plug to a torque of 34 Nm (25 lb-ft).
7-71
