TM 5-3895-382-24 Installation Procedure Table 28 Required Tools Part Tool Number Part Description Qty A 1U-762 Telescoping Magnet 1 NOTICE Keep all parts clean from contaminants. Contaminants    may    cause    rapid    wear    and    shortened component life. Illustration 169 1. Use Tool (A) to install lifters (1). NOTE: Ensure  that  the  lifters  are  seated  correctly  and that the lifters are in the correct cylinders. Camshaft - Remove and Install SMCS Code: 1210-010 Removal Procedure Start By: a. Remove the rocker shaft and the pushrods.  Refer to Disassembly    and    Assembly,    "Rocker    Shaft    and Pushrods - Remove". b. Remove the fuel transfer pump. Refer to Disassembly  and  Assembly,  "Fuel  Transfer  Pump  - Remove". c. Remove the front housing.  Refer to Disassembly and Assembly, "Housing (Front) - Remove". d. Remove  the  camshaft  gear.    Refer  to  Disassembly and    Assembly,    "Camshaft    Gear    -    Remove    and Install". NOTICE Keep all parts clean from contaminants. Contaminants    may    cause    rapid    wear    and    shortened component life. NOTICE Care  must  be  taken  to  ensure  that  fluids  are  contained during  performance  of  inspection,  maintenance,  testing, adjusting and repair of the product.  Be prepared to collect the   fluid   with   suitable   containers   before   opening   any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose  of  all  fluids  according  to  local  regulations  and mandates. 1. Turn the engine upside-down so the valve lifters are held in a position away from the camshaft. Illustration 170 2. Remove   thrust   washer   (1).      Make   a   note   of   the location    of    the    hollow    dowel    (X)    for    installation purposes. 7-67