TM 5-3895-382-24
Illustration 171
NOTICE
Do not damage the lobes or the bearings when the
camshaft is removed.
3.
Carefully remove camshaft (2) from the engine.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 172
NOTICE
Do not damage the lobes or the bearings when the
camshaft is removed.
NOTE: Ensure that camshaft (2) is clean. Lubricate
camshaft (2) with clean engine oil prior to
installation.
1.
Carefully install camshaft (2) in the engine.
Illustration 173
2.
Put thrust washer (1) in position. Make sure that thrust
washer (1) is aligned with hollow dowel (X).
End By:
a.
Install the camshaft gear. Refer to Disassembly and
Assembly, "Camshaft Gear - Remove and Install".
b.
Install the front housing. Refer to Disassembly and
Assembly, "Housing (Front) - Install".
c.
Install the fuel transfer pump. Refer to Disassembly
and Assembly, "Fuel Transfer Pump - Install".
d.
Install the rocker shaft and the pushrods. Refer to
Disassembly and Assembly, "Rocker Shaft and
Pushrods - Install".
Camshaft Gear - Remove and Install
SMCS Code: 1210-010-GE
Removal Procedure
Table 29
Required Tools
Part
Tool
Number
Part Description
Qty
1U-6671
Puller Group
1
4S-4712
Bolt
2
A
1P-0510
Driver Group
1
7-68
