TM 5-3895-382-24
Illustration 167
8.
Gradually tighten all of the bolts (1 through 22) in a
numerical sequence to a torque of 110 Nm (80 lb-ft).
9.
Tighten all of the bolts (1 through 22) again in a
numerical sequence to a torque of 110 Nm (80 lb-ft).
10.
Place an index mark on the bolts and use Tool (B) in
order to further tighten the bolts.
a.
Turn the short bolts that are marked with an "S" for an
additional 150 degrees (2.5 flats).
b.
Turn the medium length bolts that are marked with an
"M" for an additional 180 degrees (3.0 flat).
c.
Turn the long bolts that are marked with an "L" for an
additional 210 degrees (3.5 flats).
NOTE:
Refer to the Testing and Adjusting Module,
"Cylinder Compression" for the correct procedure
to test the cylinder head.
End By:
a.
Install the rocker shaft and the pushrods. Refer to
Disassembly and Assembly, "Rocker Shaft and
Pushrod - Install".
b.
Install
the
water
outlet
manifold.
Refer
to
Disassembly and Assembly, "Water Outlet Manifold -
Install".
c.
Install the exhaust manifold. Refer to Disassembly
and Assembly, "Exhaust Manifold - Remove and
Install".
d.
Install the air inlet manifold. Refer to Disassembly
and Assembly, "Air Inlet Manifold - Install.
e.
Install
the
fuel
injection
nozzles.
Refer
to
Disassembly and Assembly, "Fuel Injection Nozzles -
Install".
Lifter Group - Remove and Install
SMCS Code: 1209-010
Removal Procedure
Table 27
Required Tools
Part
Tool
Number
Part Description
Qty
A
1U-7262
Telescoping Magnet
1
Start By:
a.
Remove the camshaft. Refer to Disassembly and
Assembly, "Camshaft -Remove and Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 168
1.
Use Tool (A) to remove lifters (1).
NOTE:
Ensure that the lifters are marked with the
appropriate cylinder number for installation
purposes.
7-66
