TM 5-3895-382-24
Illustration 163
3.
Remove cylinder head gasket (3).
4.
Note the location of dowels (4) on each end of the
cylinder block. Dowels (4) hold cylinder head gasket (3)
in place while cylinder head (2) is installed.
Cylinder Head - Install
SMCS Code: 1100-012
Installation Procedure
Table 26
Required Tools
Part
Tool
Number
Part Description
Qty
A
9U-6238
Guide Bolt
2
B
8T-3052
Degree Wheel
1
1.
Thoroughly clean the top of the cylinder block and the
bottom of the cylinder head. Ensure that there is no
debris in the cylinder bores.
Illustration 164
2.
Place cylinder head gasket (3) on dowels (4) on top of
the cylinder block. The cylinder head gasket (3) is
stamped "FRONT TOP". Do not use any sealant or
compound on the cylinder head gasket.
3.
Install Tool (A) in positions 15 and 20 in the cylinder
block. Refer to Illustration 167.
Illustration 165
Typical example.
4.
Attach a suitable lifting device to cylinder head (2).
5.
Place cylinder head (2) on the cylinder block. Ensure
that the cylinder head is positioned on dowels (4) and
that cylinder head gasket (3) is positioned correctly.
6.
Remove Tool (A).
Illustration 166
Typical example.
7.
Lubricate cylinder head bolts (1) with dean engine oil.
7-65
