TM 5-3895-382-24
Crankshaft Front Seal - Install
SMCS Code: 1160-012
Installation Procedure
Table 22
Required Tools
Part
Tool
Number
Part Description
Qty
A
9U-6210
Front Seal Installer
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Clean the housing for the crankshaft front seal and
inspect the housing for damage.
2.
Lubricate the crankshaft front seal with clean engine oil.
Illustration 131
3.
Place crankshaft front oil seal (1) into the housing.
NOTICE
Ensure that the lip of the crankshaft front seal that is
spring loaded is facing toward the inside of the front
housing and that it is square with the bore of the housing
for the crankshaft front seal.
Illustration 132
4.
Use Tool (A) to install crankshaft front oil seal (1).
5.
Apply clean engine oil on the area of the crankshaft
pulley that will be in contact with crankshaft front seal
(1).
End By:
a.
Install the crankshaft pulley. Refer to Disassembly
and Assembly, "Crankshaft Pulley -Remove and
Install".
Front Cover - Remove
SMCS Code: 1166-011
Removal Procedure
Start By:
a.
Remove the crankshaft pulley. Refer to Disassembly
and Assembly, "Crankshaft Pulley - Remove and
Install".
b.
Remove the water pump. Refer to Disassembly and
Assembly, "Water Pump - Remove".
c.
Remove the alternator. Refer to Disassembly and
Assembly, "Alternator - Remove and Install"
7-54
