TM 5-3895-382-24
Illustration 118
3.
Install Tool (A) and a suitable lifting device on flywheel
(1) and position flywheel (1) and the ring gear in the
flywheel housing. The weight of flywheel (1) is 53 kg
(120 lb).
Illustration 119
4.
Install six bolts (2) and the washers. Tighten the bolts to
a torque of 105 Nm (77 lb-ft).
5.
Install bearing housing (4) and four bolts (3).
6.
Refer to the Specifications Module for additional
information on the installation of the flywheel and the
ring gear.
Crankshaft Rear Seal - Remove
SMCS Code: 1161-011
Removal Procedure
Start By:
a.
Remove the flywheel housing. Refer to Disassembly
and Assembly, "Flywheel Housing - Remove and
Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the machine. Be prepared to
collect the fluid with suitable containers before opening
any compartment or disassembling any component
containing fluids.
Dispose of all fluids according to local regulations and
mandates.
Illustration 120
1.
Remove ten bolts (1).
2.
Remove two socket head bolts (2).
3.
Remove the crankshaft rear seal, the gasket, and
housing (3) from the dowels in the cylinder block.
7-49
