TM 5-3895-382-24 Flywheel Housing - Remove and Install SMCS Code: 1157-010 Removal Procedure Table 19 Required Tools Part Tool Number Part Description Qty A 6V-2156 Link Bracket 2 Start By: a. Remove    the    electric    starting    motor.        Refer    to Disassembly and Assembly, "Electric Starting Motor - Remove and Install". b. Remove   the   flywheel.      Refer   to   Disassembly   and Assembly, "Flywheel - Remove". NOTICE Keep all parts clean from contaminants. Contaminants   may   cause   rapid   wear   and   shortened component life. NOTICE Care  must  be  taken  to  ensure  that  fluids  are  contained during  performance  of  inspection,  maintenance,  testing, adjusting  and  repair  of  the  machine.    Be  prepared  to collect  the  fluid  with  suitable  containers  before  opening any    compartment    or    disassembling    any    component containing fluids. Dispose  of  all  fluids  according  to  local  regulations  and mandates. 1. Support   the   engine   with   blocks   or   a   suitable   lifting device on a flat level surface. Illustration 124 2. Remove two bolts (1) on the top of flywheel housing (2). Illustration 125 3. Attach Tool (A) and support the flywheel housing. 4. Remove six bolts (3). 5. If necessary, hit flywheel housing (2) with a soft hammer in order to remove flywheel housing (2).  The weight of flywheel housing (2) is 32 kg (70 lb). Installation Procedure Table 20 Required Tools Part Tool Number Part Description Qty A 6V-2156 Link Bracket 2 1. Clean the rear face of the cylinder block and the face of the flywheel housing.  Inspect the felt seal on the rear flange  of  the  engine  oil  pan.    Replace  the  felt  seal,  if necessary.    Inspect  the  dowels  for  damage.    Replace the dowels, if necessary. 7-51