TM 5-3895-382-24
c.
Install
the
crankshaft
pulley.
Refer
to
Disassembly and Assembly, "Crankshaft Pulley -
Remove and Install".
Gear Group (Front) - Remove
SMCS Code: 1206-011
Removal Procedure
Table 24
Required Tools
Part
Tool
Number
Part Description
Qty
A
8S-2264
Puller Group
1
Start By:
a.
Remove the front cover. Refer to Disassembly and
Assembly, "Front Cover - Remove".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Align the timing marks on the crankshaft gear, the
camshaft gear, and the idler gear.
Illustration 136
2.
Remove three bolts (1) from idler gear (2).
3.
Remove idler near (2) and retainer plate (3).
Illustration 137
4.
Remove bushing (4) from idler gear (2), if necessary.
5.
Remove the bushing with a suitable puller. If the
bushing cannot be removed with a puller, grind the face
off of one bushing. The remainder of the bushing can
then be removed with a press.
Illustration 138
6.
Remove idler gear hub (5).
7.
Remove nut (6) and the spring washer from fuel
injection pump gear (8).
8.
Remove four bolts (7) from fuel injection pump gear (8).
9.
Use Tool (A) to remove fuel injection pump gear (8).
7-56
