TM 5-3895-382-24
Illustration 126
2.
Use Tool (A) to position flywheel housing (2) on the
dowels that are on the cylinder block.
Illustration 127
3.
Install six bolts (3).
NOTE:
The bolts for the flywheel housing have the
following torque:
a.
The M10 bolts in a cast iron flywheel housing have a
torque of 44 Nm (33 lb-ft).
b.
The M12 bolts in a cast iron flywheel housing with a
stamp 8.8 have a torque of 75 Nm (55 lb-ft).
c.
The M12 bolts in a cast iron flywheel housing with a
stamp 10.9 have a torque of 115 Nm (85 lb-ft).
d.
The M10 bolts in an aluminum flywheel housing have
a torque of 70 Nm (52 lb-ft).
4.
Install two bolts (1).
End By:
a.
Install the flywheel. Refer to Disassembly and
Assembly, "Flywheel - Install".
b.
Install the electric starting motor. Refer to
Disassembly and Assembly, "Electric Starting Motor -
Remove and Install".
Crankshaft Pulley - Remove and Install
SMCS Code: 1205-010
Removal Procedure
Start By:
a.
Remove the V-Belts. Refer to Disassembly and
Assembly, "V-Belts - Remove and Install".
Illustration 128
Typical example.
1.
Remove three bolts (2) and washer (3).
2.
Remove crankshaft pulley (1).
NOTE:
Some engines have a water immersion seal that is
placed on the front cover. The seal has a flexible
lip on the front. The plastic mandrel that is
supplied with the seal must be installed in the
seal when the crankshaft pulley is removed. This
will ensure that the lip maintains the correct
shape.
7-52
