TM 5-3895-382-24 Installation Procedure Illustration 129 Typical example. 1. Remove the plastic mandrel, if necessary. 2. Install crankshaft pulley (1). 3. Lubricate bolts with clean engine oil. 4. Install washer (3) and three bolts (2).  Tighten the bolts to a torque of 115 Nm (85 lb-ft). End By: a. Install    the    V-Belts.        Refer    to    Disassembly    and Assembly, "V-Belts - Remove and Install". Crankshaft Front Seal - Remove SMCS Code: 1160-011 Removal Procedure Table 21 Required Tools Part Tool Number Part Description Qty A 1U-8145 Drill Bit 1 B 1U-7600 Slide Hammer Puller 1 Start By: a. Remove the crankshaft pulley.  Refer to Disassembly and   Assembly,   "Crankshaft   Pulley   -   Remove   and Install". NOTICE Keep all parts clean from contaminants. Contaminants    may    cause    rapid    wear    and    shortened component life. NOTICE Care  must  be  taken  to  ensure  that  fluids  are  contained during  performance  of  inspection,  maintenance,  testing, adjusting   and   repair   of   the   machine.      Be   prepared   to collect  the  fluid  with  suitable  containers  before  opening any    compartment    or    disassembling    any    component containing fluids. Dispose  of  all  fluids  according  to  local  regulations  and mandates. Illustration 130 Typical example. 1. Use   Tool   (A)   to   drill   three   evenly   spaced   holes   in crankshaft front seal (1). 2. Place    Tool    (B)    in    the    holes    in    order    to    remove crankshaft  front  seal  (1).    Use  Tool  (B)  in  each  of  the three holes to evenly remove the crankshaft front seal. NOTE: Do not damage the flange of the crankshaft during the removal process for the crankshaft front seal. NOTICE Ensure  that  the  main  lip  is  used  in  order  to  remove  the crankshaft  front  seal.    Do  not  damage  the  edge  of  the housing for the crankshaft front seal. 7-53