TM 5-3895-382-24
Crankshaft Rear Seal - Install
SMCS Code: 1161-012
Installation Procedure
Table 18
Required Tools
Part
Tool
Number
Part Description
Qty
9U-6205
Rear Seal Installer
1
A
1P-0510
Driver Group
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Inspect the condition of the gasket. Replace the gasket,
if necessary.
2.
Clean the areas of the parts that will contact each other.
Illustration 121
3.
Use Tool (A) and a suitable press to install the
crankshaft rear seal into the housing.
Illustration 122
4.
Lubricate the components with clean engine oil. Install
Tool (A) onto the crankshaft flange.
5.
Position the new gasket on the dowels in the cylinder
block.
Illustration 123
6.
Place housing (3) and the crankshaft rear seal over Tool
(A).
7.
Position housing (3) on the dowels in the cylinder block.
8.
Remove Tool (A).
9.
Install two socket head bolts (2).
10.
Install ten bolts (1). Tighten all of the bolts to a torque of
22 Nm (16 lb-ft).
End By:
a.
Install the flywheel housing. Refer to Disassembly
and Assembly, "Flywheel Housing -Remove and
Install".
7-50
