TM 5-3895-382-24
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
Illustration 69
Typical example
1.
Disconnect tube (1) from the air inlet heater.
2.
Loosen hose clamps (3) and slide the hose toward the
turbocharger.
3.
Remove four bolts (2) and remove elbow (4) from the air
inlet manifold.
Illustration 70
Typical example
4.
Remove bolts (5) that fasten air inlet manifold (6) to the
engine.
5.
Remove air inlet manifold (6).
Air Inlet Manifold - Install (Type 2 Engines and 7BJ
Engines)
SMCS Code: 1058-012
Installation Procedure
NOTE:
For a complete description of Type 1 and Type 2
engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Inspect the gaskets for wear or damage. If the gaskets
are worn or damaged, use new parts for replacement
Illustration 71
Typical example
2.
Install the gasket and air inlet manifold (6) with bolts (5).
Tighten bolts (5) to a torque of 33 N m (24 lb-ft).
7-29
