TM 5-3895-382-24 2. Install  inlet  valves  (7)  and  exhaust  valves  (7)  in  the respective positions. 3. Install valve spring seat washers (6). 4. Install new seals (5). 5. Install inner springs (3) and outer springs (4). NOTE:    Install  inner  spring’s  (3)  and  outer  springs  (4)  on the  valve  spring  sea  washers  with  the  damper coils toward the cylinder head.  This is done with double valve springs.  If single valve springs are used, the springs can be installed in either way. 6. Install valve spring retainers (2). The valve keepers can be thrown from the valve when the valve  spring  compressor  is  released.    Ensure  that  the valve keepers am properly installed on the valve stem.  To help prevent personal injury, keep away from the front of the valve keepers and valve springs during the installation of the valves. 7. Use  Tool  (A)  to  compress  inner  springs  (3)  and  outer springs (4). NOTE:    Some engines may have only a single inlet valve spring and a single exhaust valve spring. 8. Install two valve keepers (1). 9. Slowly  release  the  pressure  on  Tool  (A)  and  remove Tool (A).  Strike the top of the valves with a soft hammer in  order  to  ensure  that  the  valve  keepers  are  properly installed. NOTE:    Refer   to   the   Specifications   Module,   "Cylinder Head Valves" for more information on inlet valves and exhaust valves. 10. Use a dial indicator to check the depth of the new valves below the cylinder head.  If the depth of the new valves is below the correct depth, the valve seat inserts must be replaced.  Refer to Disassembly and Assembly, "Inlet and Exhaust Valve Seat Insets - Remove and Install". End By: a. Install    the    cylinder    head    assembly.        Refer    to Disassembly and Assembly, "Cylinder Head - Install". Inlet and Exhaust Valve Guides - Remove and Install SMCS Code: 1104-010 Removal Procedure Table 9 Required Tools Tool Part Number Part Description Qty A 1U-9136 Valve Guide Driver 1 Start By: a. Remove   the   inlet   valves   and   the   exhaust   valves. Refer    to    Disassembly    and    Assembly,    "Inlet    and Exhaust Valves - Remove and Install". NOTICE Keep all parts clean from contaminants. Contaminants   may   cause   rapid   wear   and   shortened component life. Illustration 77 1. Use Tool (A) in order to remove the valve guides from the cylinder head assembly. 2. Repeat the procedure for the remaining valve guides. 7-33