TM 5-3895-382-24
Illustration 72
Typical example
3.
Put the gasket and elbow (4) in position on the air inlet
manifold.
4.
Install four bolts (2).
5.
Slide the hose into position and tighten hose damps (3).
6.
Connect tube (1) to the air inlet heater.
Inlet and Exhaust Valve Springs - Remove and Install
SMCS Code: 1108-010
Removal Procedure
Table 5
Required Tools
Tool
Part
Number
Part Description
Qty
A
9U-6195
Valve Spring Compressor
1
Start By:
a.
Remove the rocker shaft. Refer to Disassembly and
Assembly, "Rocker Shaft and Pushrod - Remove".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTE:
Before you begin the removal of the valve
springs, refer to the Testing and Adjusting
Module, "Valve Depth Check' for appropriate
information on the valve springs.
1.
Ensure that the piston is at the top center position.
NOTE:
If the rocker arm assembly has been removed,
use the following procedure in order to find the
top center position.
NOTICE
Do not turn the crankshaft while the valve springs are
removed.
a.
Install Tool (A).
b.
Compress the valve springs in order to open the
valve.
c.
Turn the crankshaft until the piston touches the valve.
d.
Continue to turn the crankshaft and release the
pressure of Tool (A) until the piston is at the top
center position.
Illustration 73
2.
Install Tool (A).
3.
Compress valve springs (1). Remove two valve
keepers (2).
NOTICE
Ensure that the valve spring is compressed squarely or
damage to the valve stem may occur.
4.
Release the pressure on Tool (A). Remove valve spring
retainer (3) and valve springs (1).
7-30