TM 5-3895-382-24
Illustration 57
Typical example
1.
Remove exhaust manifold nuts (1).
2.
Remove exhaust manifold (2) and the gasket.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 58
Typical example
1.
Inspect the condition of the gasket. Replace the gasket,
if necessary.
2.
Install the gasket and exhaust manifold (2).
3.
Install exhaust manifold nuts (1). Tighten the plated
nuts to a torque of 44 N m (32 Ib-ft). Tighten the nuts
that are not plated to a torque of 50 N m (37 Ib-ft).
End By:
a.
Install the turbocharger. Refer to Disassembly and
Assembly, "Turbocharger - Install".
Exhaust Manifold - Remove and Install (Type 2
Engines and 7BJ Engines)
SMCS Code: 1059-010
Removal Procedure
Start By:
a.
Remove the turbocharger. Refer to Disassembly and
Assembly, "Turbocharger - Remove".
b.
Remove the air inlet manifold. Refer to Disassembly
and Assembly, "Air Inlet Manifold Remove and
Install".
NOTE:
For a complete description of Type 1 and Type 2
Engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear ant shortened
component life.
Illustration 59
Typical example
7-25