TM 5-3895-382-24
Air Inlet Manifold - Install (Type 1 Engines and 9RM
Engines)
SMCS Code: 1058-012
Installation Procedure
NOTE:
For a complete description of Type 1 and Type 2
engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Inspect the gaskets for wear or damage. If the gaskets
am worn or damaged, use new parts for replacement.
Illustration 67
Typical example
Illustration 68
Typical example
2.
Install seal (1) on the engine.
3.
Position gaskets (11) and air inlet manifold (14) on the
engine.
NOTE:
Ensure that the front gaskets and the rear gaskets
are installed with the notch at the top left side.
The center gasket can be installed in either
direction.
4.
Install bolts (13).
5.
Position the turbocharger support on air inlet manifold
(14) and install bolts (12).
6.
Connect boost pressure hose (10).
7.
Install gasket (4) and elbow (2) with four bolts (3).
8.
Slide hose (9) in position and tighten hose clamps (8).
9.
Place the bracket for fuel line (6) in position and install
two bolts (7).
10.
Connect fuel line (6) to the air inlet heater.
11.
Connect electrical connector (5) for the air inlet heater.
Air Inlet Manifold - Remove (Type 2 Engines and 7BJ
Engines)
SMCS Code: 1058-011
Removal Procedure
NOTE:
For a complete description of Type 1 and Type 2
engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
7-28
