SECTION 9
STEERING
e. Torque the capscrews to specification (see figure
f. Install the front scraper bar. Lubricate the axle shaft
assembly (refer to Section 4). See figure 9-115.
9-97. REMOVAL AND DISASSEMBLY OF YOKE AND
KING PIN ASSEMBLY.
NOTE:
Remove axle shaft assembly from unit by
following procedures outlined in paragraph 9-
91. Then proceed as follows:
a. Remove scraper bar and coco mat assembly, water
spray manifold and disconnect steering cylinder ball joint
assembly (see figure 9-116).
FIGURE 9-113.
FIGURE 9-114.
FIGURE 9-116.
FIGURE 9-117.
FIGURE 9-115.
9-36.