SECTION 9
STEERING
shaft assembly away from the unit (see figure 9-100).
d. Perform steps a and b on the remaining drum, then
pull the axle shaft from the drum.
9-93.
DISASSEMBLY OF AXLE SHAFT ASSEMBLY
e. Remove seals, bearings, shim(s) and center spacer
(see figure 9-101).
from axle shaft.
NOTE:
Remove axle shaft assembly from unit by
CAUTION: Tag bearings and shim(s) for reassembly into
following procedure outlined in paragraph 9-91.
same position.
Then position axle shaft assembly on a hard
level surface.
f.
Clean and inspect components per paragraph 9-94.
a. Remove cotter pin, slotted nut, and thrust washer
9-94. CLEANING AND INSPECTION.
from one side.
a. Clean all parts in solvent or other suitable cleaning
b. Remove split spacers and solid spacer.
Tag for
agent. Dry thoroughly with compressed air or clean lint-
reassembly into same position.
free cloth. If parts are not to be assembled immediately,
coat all machined surfaces with clean oil and cover.
c. Slightly lift the drum (with components removed)
and slide the drum off of the axle.
FIGURE 9-99.
FIGURE 9-97.
FIGURE 9-100.
FIGURE 9-98.
9-32.