SECTION 9
STEERING
9-96.
INSTALLATION OF
GUIDE
ROLLS
AND
STEERING AXLE ASSEMBLY.
a. Lift axle shaft assembly so it parallels the position of
the steering yoke (see figure 9-110).
b. Lift the gooseneck up until the steering yoke clears
the axle shaft spacers. Then carefully roll the guide rolls
until yoke is directly over the axle shaft (see figure 9-111).
c. Position the spacer slits so they line up with the slits
between the caps and the steering yoke. Remove the
frame blocking and lower the gooseneck until the axle shaft
carries the weight (see figure 9-112).
d. Install each cap on the original side it was removed
FIGURE 9-108.
from. Be sure groove (larger I. D.) is to the outside (see
FIGURE 9-111.
FIGURE 9-109.
FIGURE 9-112.
FIGURE 9-110.
9-35.