SECTION 9
STEERING
e. Lift off the meter gear star (see figure
solvent, they should be blown dry with an air
9-13) and place it in the meter gear ring remov-
hose and stored in a clean place.
ed in step d.
a. Place the unit in a vise with soft jaws,
f. Remove the long space (see figure 9-14).
control end up. Clamp across port surface and
opposite side of housing lightly. Remove the
g. Remove the splined spacer (see figure
two capscrews that fasten the column to lower
unit (see figure 9-8). Remove the column (see
figure 9-9). Mark the two capscrew holes so
h. Lift off the second meter gear ring (see
that the ports will be in the proper direction
when reassembled.
b. Turn the housing assembly over so that
metering section is up. Holding the assembly
in the soft jaws of the vise, remove the seven
(7) capscrews (see figure 9-10).
c. Lift off the meter end cap (see figure
d. Remove the meter gear ring (see figure
FIGURE 9-15.
FIGURE 9-14.
i. Remove the second meter gear star and
place it in the second meter gear ring (see
CAUTION: Do not mix the ring and star gears
between the two tandem mounted
metering assemblies.
j. Remove the short spacer (see figure 9-17)
and lift out the drive (see figure 9-18).
FIGURE 9-9.
FIGURE 9-8.
FIGURE 9-10.
FIGURE 9-11.
FIGURE 9-17.
FIGURE 9-16.
FIGURE 9-12.
FIGURE 9-13.
FIGURE 9-18.
FlGURE 9-19.
9-7.