SECTION 7
TRANSMISSION
FIGURE 7-67.
FIGURE 7-69.
tower.
f. Work the output shaft back into its bore
as far as possible.
(2). With the crank pin slot in the yoke In
line with the crank pin, lower the yoke into
g. Install the snap ring on the output shaft
the tower (see figure 7-70). Align the yoke
bearing. With snap ring out, slide the bearing
bore with the end of the shaft in the tower.
over the shaft and push it against the wear
Push the shaft partially into the bore.
plate.
(3). Drop the spring into the hole between
h. Lift the output shaft by both ends. Align
the yoke plates. Place the detent ball on top
the bearing with its bore. Start the bearing into
of it. Insert a punch into the hole. Push the
its bore (see figure 7-69). Push the bearing into
detent ball down and push the shaft into the
the bore until the snap ring contacts the case.
yoke bore and over the detent ball and
spring, withdrawing the punch at the same
i. Install the shifter yoke, if it has been
time (see figure 7-71).
removed, as follows:
(4). Rotate the shaft until the detents are on
(1). Start the yoke shaft into one of its bores
the ball side. Push the shaft through the
in the tower. Push the shaft partially into the
FIGURE 7-70.
FIGURE 7-68.
7-20.