TM 5-3895-346-14
STEERING CONTROL DISASSEMBLY
POWER STEERING
Figure 18.
Figure 20
Figure 19.
Figure 21
Push centering spring set out of spring slot in spool (refer to Fig. 21 and 22).
At this point all parts have been disassembled and removed from the unit. Each should be rinsed carefully in
clean solvent, even such exterior parts as all capscrews and all seals that appear to be reusable. If in doubt,
replace with new seals. It is good service policy to replace all seals when unit is reassembled. They are
available in kit form, part no. 5140. Rinsing and cleaning can be done while other parts of the unit are being
dis- assembled and parts can be set to dry on clean paper towel. The meter gear set must be disassembled
and cleaned similarily.
582
