TM 5-3895-346-14
POWER STEERING
STEERING CONTROL REASSEMBLY
Bring spring slots of both parts in line and stand parts on end of bench. Insert spring installation tool through
spring slots of both parts. Tool is available as part no. 600057. Position 3 pairs of centering springs (or 2 sets
of 3 each) on bench so that extended edge is down and arched center section is together. In this position, enter
one end of entire spring set into spring installation tool (refer to Fig. 30).
Compress extended end of centering spring set and push into spool sleeve assembly withdrawing installation
tool at the same time (refer to Fig. 31).
Figure 27.
Figure 28.
Figure 29.
Figure 30.
Figure 31.
585
