TM 5-3895-346-14
POWER STEERING
STEERING CONTROL DISASSEMBLY
Figure 6.
Figure 8.
Figure 7.
Figure 9.
Place clean woodblock across vise throat to support spool parts and clamp unit across port face with control
end up. Remove and set aside four capscrews (refer to Fig. 8).
Hold spool assembly down against block in vise and lift off end cap (refer to Fig. 9).
Inspect mating surfaces for obvious leakage path, wear, and seal condition (refer to Fig. 10).
Remove cap locator bushing (refer to Fig. 11).
Place housing on solid surface with port face down so that it can be held securely and remove spool-sleeve as-
sembly from the 14-hole end of housing (refer to Fig. 12).
579
