TM 5-3895-346-14
POWER STEERING
STEERING CONTROL REMOVAL
Assembly is generally easier and more satisfactory with clean, dry parts. After parts are rinsed clean in solvent
they may be blown dry with an airhose or placed on clean paper towel to drain and air dry.
If parts are thus prepared as they are removed, they are frequently ready for reassembly by the time they are
needed.
NOTE
The following procedure applies to all units with Model numbers starting with U or
W. They can be identified by a one-piece housing and a check hole plug with an
O-ring at about the middle of the O.D.
577