TM 5-3895-346-14
STEERING CONTROL REASSEMBLY
POWER STEERING
Center the spring set in the parts so that they push down evenly and flush with the upper surface of the spool
and sleeve (refer to Fig. 32).
Install cross pin through spool assembly (refer to Fig. 33).
Push into place until cross pin is flush or slightly below the sleeve diameter at both ends (refer to Fig. 34).
Position the housing on a solid surface with the port face down. Start the spool assembly so that the splined
end of the spool enters the 14-hole end of the housing first (Refer to Fig. 35).
Figure 32
Figure 33
Figure 34
Figure 35
586
