TM 5-3895-383-24
Disassemble Axle Propel Motor
5058-015
Start By:
a.
remove axle propel motor
NOTICE
Dirt can damage precision made parts of the motor.
Disassemble the motor on a clean work surface. Clean all
the parts separately in clean solvent and let the parts dry
at room temperature. Check the condition of all parts and
refer to Guideline For Reusable Parts, Piston Pumps And
Motors,
Form
No.
SEBF8032-01
as
a
guide
for
reconditioning and determining the reusability of parts.
1.
Remove the four bolts, and remove flushing valve (8)
and three O-ring seals (25) from rear cover (7). Check
the O-ring seals for wear or damage and replace if
necessary.
2.
Disassemble flushing valve (8) using the following
procedure.
a.
Remove plug (17), shim (18), spring (20) and relief
valve poppet (21) from valve body (26). Remove
orifice (22) and retainer (23) from valve poppet (21).
b.
Remove O-ring seal (19) from plug (17). Check the
O-ring seal for wear or damage and replace if
necessary.
c.
Remove plug (14), spring (16) and guide (24) from the
valve body.
14-55
