TM 5-3895-383-24
32.
Install shaft seal (11), shim (10) and retaining ring (9) in
housing (1).
33.
Install O-ring seal (6) on the housing.
34.
Install two dowel pins (53) in end cover (7).
35.
Install minimum displacement adjustment screw (2) in
housing (1) to its original depth, and tighten nut (3).
36.
Install maximum displacement adjustment screw (12) in
housing (1) to is original depth, and tighten nut (13).
37.
Install O-ring seal (41) on plug (34). Install throttle
screw (44), check valve shuttle (43), throttle screw (42)
and plug (34) in end cover (7).
38.
Install throttle screw (40), throttle pin (39), throttle screw
(37) and plug (33) in end cover (7).
39.
Install throttle screw (38), throttle pin (36), throttle screw
(35) and plug (32) in end cover (7).
40.
Install control bushing (52) in the end cover, and install
retaining ring (51).
41.
Install O-ring seal (49) on plug (50). Install plug (50) in
the end cover.
42.
Install O-ring seal (46) on plug (45). Install spool (48),
spring (47) and plug (45) in end cover (7).
43.
Install O-ring seal (57) on plug (56). Align the hole in
the stroking piston with the slot in the end cover. Install
stroking piston (58) and plug (56) in end cover (7).
44.
Install swivel trunnion (55) in the stroking piston. Install
control lens (5) on the swivel trunnion.
45.
Position end cover (7) on dowel pins (53) and housing
(1), and install the eight bolts.
14-59
