TM 5-3895-383-24
46.
Install three O-ring seals (54) in end cover (7).
47.
Assemble flushing valve (8) using the following
procedure:
a.
Install O-ring seal (30) on plug (31).
b.
Install spool (27), guide (28), spring (29) and plug (31)
in valve body (26).
c.
Install O-ring seal (15) on plug (14).
d.
Install guide (24), spring (16) and plug (14) in the
valve body.
e.
Install O-ring seal (19) on plug (17).
f.
Install relief valve poppet (21), spring (20), shim (18)
and plug (17) in valve body (26).
48.
Position flushing valve (8) on the end cover, and install
the four bolts.
End By:
a.
Install axle propel motor
Wheel Drive Gearbox
Remove & Install Wheel Drive
Gearbox 4053-010
Start By:
a.
Remove axle propel motor
1.
Position a floor jack or similar lifting device under the
axle gearbox. Remove six bolts (2). Remove axle gear
reducer (1) and O-ring seal. The weight of the axle gear
reducer is 25 kg (55 lb). Check the O-ring seal for wear
or damage and replace if necessary.
NOTE:
For installation of the axle gear reducer, reverse
the removal step.
End By:
a.
install axle propel motor
14-60
