TM 5-3895-383-24
6.
If necessary, remove the fuel pressure relief valve (4).
NOTE:
The following steps are for the installation of the
fuel filter base and fuel filter.
7.
Check the condition of the gasket for the fuel filter base,
the O-ring seal for breather assembly (1) and the O-ring
seals used in the tube assemblies that connect to the
fuel filter base. If the gasket and seals are damaged,
use new parts for replacement.
8.
Put the gasket and fuel filter base in position on the
engine. Install the four bolts (5) and the washers that
hold it.
9.
Connect the two tube assemblies (3) and (4) to the fuel
filter base.
10.
Install the O-ring seal and breather assembly (1) on the
fuel filter base. Tighten the bolt that holds the breather
assembly to a torque of 7 2 Nm (5.0 1.5 lb-ft).
11.
Connect the hose assembly (2) to the breather
assembly (1).
12.
Install the fuel filter (6). For information regarding the
filter installation and service intervals, refer to the
Operation & Maintenance manual.
Fuel Shutoff Solenoid
Remove & Install Fuel Shutoff
Solenoid 1259-010
Tools Needed
A
9U-5120 Spanner Wrench
1
Fluid Spillage Containment
Care must be taken to ensure that fluids are contained during
performance of inspection, maintenance, testing, adjusting and
repair of the machine. Be prepared to collect the fluid with
suitable containers before opening any compartment or
disassembling any component containing fluids. Refer to
"Tools And Shop Products Guide", NENG2500 for tools and
supplies suitable to collect and contain fluids in Caterpillar
machines. Dispose of fluids according to local regulations and
mandates.
1.
Disconnect the wiring harness from the fuel shutoff
solenoid.
2.
Using Tool (A), remove the fuel shutoff solenoid from
the governor.
3.
Remove the O-ring seal from the fuel shutoff solenoid.
NOTE:
The following steps are for the installation of the
fuel shutoff solenoid.
4.
Check the condition of the O-ring seal used on the fuel
shutoff solenoid. If the seal is damaged, use a new part
for replacement. Install the O-ring seal on the fuel
shutoff solenoid.
5.
Install the fuel shutoff solenoid in the governor. Using
Tool (A) and a suitable torque wrench, tighten the fuel
shutoff solenoid to a torque of 30 5 Nm (22 4 lb-ft).
6.
Connect the wiring harness to the fuel shutoff solenoid.
8-13
