TM 5-3895-382-24
NOTICE
During removal, do not damage valve plate (36).
17.
Put an identification mark on valve plate (36) as to its
location in housing (2) and locating pin (38). Remove
valve plate (36) from the housing. If necessary, remove
locating pin (38).
18.
Remove two dowels (37) and gasket (39) from housing
(2). Remove any of the gasket material from front cover
(17).
19.
Remove needle bearing (40) from the housing.
NOTICE
Servo pistons (41) and (42) are different. Put identification
marks on the servo pistons so they can be installed in
their original location in the housing.
20.
Remove servo pistons (41) and (42) from housing (2).
21.
Remove hollow piston (44) from each of the servo
pistons. If necessary, remove slipper (43) from each of
the hollow pistons.
22.
Remove seal rings (45) from each of the servo pistons.
16-60
