TM 5-3895-382-24
29.
Install servo pistons (41) and (42) in housing (2). If
necessary, compress the seal rings when installing the
servo pistons.
30.
Install needle bearing (40) in the housing. Install the
needle bearing until it makes contact with the
counterbore in the housing and with the printed number
on the bearing facing up.
31.
Install locating pin (38) in housing (2). Install valve plate
(36) in its original position in the housing. Make sure
the valve plate is engaged with the locating pin.
32.
Install washer (35), spring (33) and washer (32) in the
cylinder block. Put the cylinder block in a press Install a
suitable piece of square steel stock against washer (32).
Using a press, compress spring (33), and install
retaining ring (34). Slowly release the spring
compression.
NOTE:
Position pin retainer (30) at the top of the cylinder
block splines.
33.
Install three pins (31) and pin retainer (30) in the
cylinder block.
34.
Install retainer guide (29) on the cylinder block.
16-62
