TM 5-3895-382-24
42.
Position front cover (17) on the gas ket and housing (2),
and install eight bolts (16).
43.
Put clean grease on the inside diameter of lip seal (14).
Install the seal in front cover (17), and install retaining
ring (15).
44.
Install O-ring seal (11) and servo stop (13) in servo
cover (6). Position spring (9) and servo cover (6) on
housing (2), and install four bolts (4).
45.
Install O-ring seal (10) in servo cover (5). Position
spring (8), stop (12), spring (7) and servo cover (5) on
the housing, and install two longer bolts (3). Install two
original bolts (3). Remove the two longer bolts, and
install the two remaining original bolts.
16-64
