TM 5-3895-382-24
Disassemble & Assemble Drum
Propel Motor (CS-433C & CP-433C)
4351-010
Tools Needed
A
2P-8312
Pliers
1
Start By:
a.
remove drum propel motor
1.
Remove caps and fittings (1) from housing (2).
There is spring pressure when servo cover (5) is removed.
Use longer bolts (3) as described to release the spring
tension and prevent possible personal injury.
2.
Remove two bolts (3) that am opposite each other.
Install two M6 X 2.0 X 50 mm bolts. Remove the
remaining two bolts (3). Slowly and evenly, remove the
two longer bolts to release the spring tension.
3.
Remove servo cover (5), spring (7), stop (12) and spring
(8) from housing (2). Remove O-ring seal (10) from the
servo cover. Check the O-ring seal for damage or wear
and replace if necessary.
4.
Remove four bolts (4), and remove servo cover (6) and
spring (9) from housing (2). Remove O-ring seal (11)
from the servo cover. Check the O-ring seal for damage
or wear and replace if necessary. If necessary, loosen
the nut, and remove servo stop (13) from servo cover
(6).
16-57
