TM 5-3895-382-24
11.
Use Tool (A) to remove cylinder block assembly (25)
from housing (2).
12.
Remove seven pistons (26) and slipper guide (27) from
cylinder block (28).
13.
Remove retainer guide (29) from the cylinder bock.
14.
Remove pin retainer (30) and three pins (31) from the
cylinder block.
There is spring force against washer (32). When retaining
ring (34) is removed, the spring force will be released. To
prevent possible personal injury, removal of the internal
components in cylinder block (28) should be performed in
a press in order to retain spring (33) and washer (32).
15.
Put cylinder block (28) in a press. Install a suitable
piece of square steel stock against washer (32). Put
slight compression on washer (32) with the press.
Remove retaining ring (34), and slowly release the
spring compression.
NOTICE
Washers (32) and (35) are different in size. Put
identification marks on the washers so they can be
installed in their original location in the cylinder block.
16.
Remove washer (32), spring (33) and washer (35) from
the cylinder block.
16-59
