TM 5-3895-382-24
15.
Put cylinder block (11) in a press. Install a suitable drive
plate on notched washer (15) and compress spring (17)
until retaining ring (16) can be installed.
16.
Install retainer (14), three pins (13) and retainer guide
(12).
17.
Install the nine pistons (9) according to their original
location in the slipper guide (10) and cylinder block (11).
Move the slipper guide (10) from side to side to ensure
the piston assemblies (9) move freely in the cylinder
block (11).
18.
Lay housing (7) on side and install rotary group (8).
19.
Using a press, install needle bearing (5). Install locating
pin (6), gasket (4), and valve plate (3).
20.
Position end cap (2) on motor and install four bolts (1).
Tighten four bolts (1) to a torque of 47 to 61 N· m
(35 to 45 lb-ft)
16-55